The visual representation of the component used in your circuit diagrams.

Locate your current User Database. The default path is usually: C:\Users\ \AppData\Local\National Instruments\Circuit Design Suite\ \database\

Place your new component in a simple test circuit: for a MOSFET, this might be a basic switching test with a resistive load and a pulse generator. Run a transient simulation and compare the output waveform against the datasheet's typical characteristics.

| Document Type | Storage Location | Core Constraint | Engineering Risk Point | |---|---|---|---| | Symbol | .mdb Symbols table | Pin names, electrical type (I/O/BIDIR/PWR), graphical coordinates | If a GND pin is labeled as I/O , the SPICE netlist will miss the ground path entirely | | Model | Same .mdb Models table or external .lib | SPICE syntax compliance, complete default parameters, no undefined variables | A MODEL NMOS NMOS(LEVEL=1) missing VTO will cause DC analysis to diverge | | Footprint | .mdb Footprints table | Pad sizes, silkscreen frame, 3D model path | Pads 0.1mm smaller than the actual chip will trigger DFM warnings from the PCB manufacturer |

Select the repacked database as the and your User Database as the destination [29]. Choose the specific components or families you wish to add.

Multisim Library Repack

The visual representation of the component used in your circuit diagrams.

Locate your current User Database. The default path is usually: C:\Users\ \AppData\Local\National Instruments\Circuit Design Suite\ \database\ multisim library repack

Select the repacked database as the and your User Database as the destination [29]. Choose the specific components or families you wish to add.