Before interfacing with the keypad or software, you must understand the physical components of the V2000-c.
To manage system users or security settings, administrators must enter . All setup commands must begin from within this environment. Step 1: Entering Programming Mode V2000-c Rfid Access Control User Manual
Relay NO (Normally Open - Typical for magnetic locks/strikes) Yellow: Relay NC (Normally Closed) White: Relay COM Green: Exit Button Grey: Doorbell Before interfacing with the keypad or software, you
To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults Step 1: Entering Programming Mode Relay NO (Normally
The V2000-C RFID Access Control system is a standalone device supporting up to 2,000 users with card-only, PIN-only, or combined verification modes for single-door security. It features a stainless steel design, 12V DC power requirements, and supports Wiegand 26-bit interfacing for integration. Detailed instructions for installation and user enrollment can be found in the savebase.com manual www.goldbridgesz.com