Stenhoj Ds2 Manual -

Most DS2 models operate on a 3-phase power supply (400V).

This section dictates how to uncrate, position, and anchor the lift columns. It highlights the critical of the lifting arms. Pay close attention to the column alignment instructions; even a minor fractional variance at the base can cause premature wear on the lifting nuts and spindles. Electrical Connections stenhoj ds2 manual

Usually requires a 3-phase 400V supply, though some variants exist for 230V. 2. Installation Requirements Most DS2 models operate on a 3-phase power supply (400V)

For specific repair reports or to order replacement "safety" or "load" nuts, it is recommended to contact an authorized service partner, as they maintain the official technical archive for these legacy machines. Stenhoj Ds2 Manual Pay close attention to the column alignment instructions;

Pause lifting and vigorously shake the vehicle by the bumper to ensure it is securely seated on the rubber pads. If any slipping occurs, lower the vehicle immediately and readjust the arms.